Reznor Carryover Lighter Tube Parts Manuals - Manual

Form RZ-NA-P-X/XE-LTR-TUBE, Mfg #101147, Page 1
Installation Instructions for
Carryover Lighter Tube - Natural or
Propane Connection
Parts/Installation Form RZ-NA-P-X/XE-LTR-TUBE
Obsoletes RGM 704 (Version A)
APPLIES TO: Model Series X, RX, XE, RXE, REB
Description/Application
These carryover kits are intended for installation on Model (H) (C) RX; (H) (C) X; (H) (C) RXE; (H) (C) REB, and (H) (C) XE that did not include
factory-installed lighter tube carryovers (units manufactured prior to 11/86).
Parts List (Lighter Tube Carryover Kits are listed by Size of Heater)
WARNING: All components of the gas supply system
must be leak tested prior to placing equipment into
service. Never test for leaks with an open flame.
Failure to comply could result in severe personal
injury or death. Use an approved leak-test solution
or soap solution to detect leaks.
Size 75/100 125 150/175 200/225 250/300 350 400
For NATURAL GAS Furnace - Kit P/N 92135 92136 92137 92138 92139 92140 92141
Components:
Lighter Tube Assembly
9899 9859 9821 9783 9747 9711 9520
Length (inches) 12-3/8 15-1/8 20-5/8 26-1/8 34-3/8 39-7/8 45-3/8
Drip Shield
15015 15014 15013 15012 15011 15010 14957
Carryover Orifice
9870 9870 9680 10370 10370 9792 9792
Drill Size 70 70 65 59 59 54 54
Aluminum Tube
93389 93389 93389 93389 93389 93389 93389
Brass Elbow
93388 93388 93388 93388 93388 93388 93388
Compression Fitting
9664 9664 9664 9664 9664 9664 9664
1/2" lg, #10 Sheetmetal Screw
11813 11813 11813 11813 11813 11813 11813
Quantity 6 6 6 6 6 6 6
For PROPANE GAS Furnace - Kit P/N 92142 92143 92144 92145 92146 92147 92148
Components:
Regulated Carryover Assembly
100712 100712 100712 100712 100712 100712 100712
Lighter Tube Assembly
9899 9859 9821 9783 9747 9711 9520
Length (inches) 12-3/8 15-1/8 20-5/8 26-1/8 34-3/8 39-7/8 45-3/8
Drip Shield
15015 15014 15013 15012 15011 15010 14957
Carryover Orifice
9870 9870 9680 9680 10370 9791 9791
Drill Size 70 70 65 65 59 56 56
1/2" lg, #10 Sheetmetal Screw
11813 11813 11813 11813 11813 11813 11813
Quantity 6 6 6 6 6 6 6
Drip
Shield
Lighter
Tube
Regulated
Carryover
Assembly for
Propane Gas
Installation Instructions
1.
Turn off the gas supply upstream of
the valve and turn off the electric.
2.
Mark the wires connected to the gas
valve and disconnect.
3.
Disconnect spark lead and flame sen-
sor from the ignition controller.
CAUTION: Hold burner rack firmly and pull slowly.
4
. Remove the burner rack.
a) Remove the heater side panel.
b) Uncouple the union in the gas supply to
permit removal of the burner rack.
c) Remove the sheetmetal screws in the top
corners of the burner rack and pull the
burner rack out of the unit.
5.
Follow the illustrated instructions on
pages 1-4 to install the Lighter Tube
Carryover Kit. Test for leaks. When the
installation is complete, reverse Instal-
lation Instruction Nos. 1-4 to re-
assemble the heater. Test for proper
and safe operation.
INSTALL LIGHTER TUBE - Steps 1-6 apply both natural gas and propane gas heaters.
1. Burner rack
without
lighter tube.
2. Back off screws that
attach the manifold
to the burner rack.
Remove top screws.
®