Reznor RV 325 Option - Installation - Heater Stand Assembly - Manual

Form I-OIL-HS, P/N 122407R3, Page 1
Applies to: Oil-Fired Heater Models OH 95, 140, 190;
RA 110, 140, 150, 235, 250; RV 225, 325
and a Model OT-250 Oil Tank
Installation Instructions for Oil Tank
Heater Stand, Option ST1
Form I-OIL-HS (Version A )
Obsoletes Form I-OIL-HS
Description/
Application
Option ST1 heater stand is designed to be field-assembled to a Model OT-250
workbench oil tank for the purpose of supporting a Reznor ® oil-fired unit heater.
Adding the optional stand to the tank creates a unified tank/heater structure. Sus-
pension of the heater is not required when it is installed on the heater stand.
Select a location that will allow for required heater clearances as shown on the
rating plate and in the heater installation manual.
Components Before beginning installation, verify components against the list below.
Check for damage. If damage is found, file a claim with the transporting agency.
Assembled Tank/Heater Structures using Option ST1
Model
RA235
Model
RV225
Option ST1
Heater Stand
Model OT-250
Workbench
Oil Tank
IMPORTANT
The Option ST1 heater
stand may only be used
with a Reznor ® Model
OT-250 workbench oil
tank and one of the
Reznor heaters listed
below.
Model ......Sizes
OH ...........95, 140, 190
RA ...........110, 140, 150, 235, 250
RV ...........225, 325
DO NOT use this
heater stand with any
other models or sizes of
heaters.
Option STI Package P/N 202829
Components: Qty P/N
Structural
Parts and
Label for all
installations
Corner Post, 1-1/2” square tubing, approximately 8 feet long 4 202826
Tube Bracket Assembly, 2" square tubing 2 202828
Warning Label 2 121734
Front and Rear Support Angle 1-1/2” x 1-1/2” x 64" long 2 202827
Corner
Hardware for
all instalaltions
Hex Head Cap Screw, 1/2-13 x 3/4” 4 121593
Flat Washer, 1/2" 4 121595
Lock Washer, 1/2" 4 111306
Setscrew
Hardware for
all installations
Hex Head Cap Screw, 1/2-13 x 1-1/2” 8 121596
Jam Nut, 1/2 -13 8 45550
Angle Stops
and Hardware
(See
application
listed.)
Angle Stop, 1-1/2”x1-1/2”x1-1/4" lg w/ 3/8 & 7/32 holes - for OH & RA 4 202825
Hex Head Cap Screw, 5/16-18 x 3/4” - for OH and RA 4 16247
Hex Head Nut, 5/16-16 - for OH and RA 4 1035
Flat Washer, 5/16" - for OH and RA 4 27761
Lock Washer, 5/16 - for OH and RA 4 1333
Angle Stop, 1-1/2”x1-1/2”x1-1/4" lg w/ (2) 9/32 holes - for RV 4 202830
1/4-20 3/4" long F-point Screw - (8) for RV and (4) for RA 150, 250 8 114687