Reznor B Option - Installation - Polytube Adapter Instructions - Floor Mount - Manual (Page 2)

Form I-B-PF, Page 2
WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause
property damage, injury or death. Read the installation, operation, and maintenance instructions
thoroughly before installing or servicing this equipment.
INSTALLATION INSTRUCTIONS
Installation should be done by a qualified agency in ac-
cordance with the instructions on this sheet and in com-
pliance with all codes and requirements of authorities hav-
ing jurisdiction.
Set the heater on a wooden pallet or other substantial
material so that the heater is at least 13 inches off the floor.
Check the heater with a level and make any adjustments
to assure that the heater is level before beginning installa-
tion. The heater must be level when the blower legs
are attached.
3. Install Adapter Top and
Bottom (See Figure 5)
Determine which of the two remaining panels goes
on the top and which goes on the bottom.
Adapter Top - Position the adapter top panel with
the flange of the top over the adapter sides. Attach
the top to the front of the heater and to the adapter
side panels.
Adapter Bottom - Remove the screws in the bottom
front panel of the heater. (Use these screws when at-
taching the adapter bottom to the front of the heater.)
Position the adapter bottom panel with the flange of
the bottom over the side panels. Attach the adapter
bottom to the front of the heater and to the adapter
side panels.
Adapter Bottom
Adapter Top
1. Remove the Horizontal Louver Assembly (See
Figure 3)
Remove the screws that attach the sides of the horizontal louver assembly to
the inner side panels of the heater.
Remove the louver assembly.
2. Install the Adapter Sides (See Figure 4)
Before attaching the side panels, determine their correct positioning depend-
ing on the desired configuration.
Using the holes that held the louver assembly, attach the adapter side panels
to the heater. At the remaining hole locations (pre-punched in the adapter
sides), drill 3/32" diameter holes. Insert screws and tighten.
Adapter
Right
Side
Top Front
Panel
Remove Screw
(both sides) to
Remove Louver
Assembly
Remove Screw
(both sides)
Bottom Front
Panel
(Remove center
screws in Step 5)
Adapter
Left
Side
Figure 3 - Blower-Type Unit Heater with Standard
Horizontal Louver Assembly (Remove Louver Assembly to
Install Polytube Adapter)
Figure 4 - Attach Polytube Adapter
Sides
Figure 5 -
Install
Adapter
Top and
Bottom