Disclaimer, Copyright notice, Trademark disclaimer – RED 4K BROADCAST MODULE User Manual

Page 3: Compliance statements, Disclaimer 3, Red 4k broadcast module operation guide

RED 4K BROADCAST MODULE OPERATION GUIDE

955-0072, REV-D | 3

DISCLAIMER

RED has made every effort to provide clear and accurate informa-

tion in these installation instructions, which are provided solely for

the user’s information. While thought to be accurate, the informa-

tion in this document is provided strictly “as is” and RED will not

be held responsible for issues arising from typographical errors or

user’s interpretation of the language used herein that is different

from that intended by RED. All safety and general information is

subject to change as a result of changes in local, federal or other

applicable laws.
RED reserves the right to revise this document and make changes

from time to time in the content hereof without obligation to notify

any person of such revisions or changes. In no event shall RED, its

employees or authorized agents be liable to you for any damages

or losses, direct or indirect, arising from the use of any technical or

operational information contained in this document.
For comments or questions about content in this Operation Guide,

please send a detailed e-mail to

[email protected]

COPYRIGHT NOTICE

code, and product names used in association with the accompa-

nying product are the copyrights, trademarks or other intellectual

property owned and controlled exclusively by RED.COM, INC.

TRADEMARK DISCLAIMER

All other company, brand and product names are trademarks or reg-

istered trademarks of their respective holders. RED has no affiliation

to, is not associated or sponsored with, and has no express rights

in third-party trademarks. Torx is a registered trademark of Acument

Intellectual Properties, LLC in the United States or other countries.

COMPLIANCE STATEMENTS

INDUSTRIAL CANADA EMISSION COMPLIANCE STATEMENTS

This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme

NMB-003 du Canada.

FEDERAL COMMUNICATIONS COMMISSION (FCC) STATE-

MENTS

This equipment has been tested and found to

comply with the limits for a Class B digital de-

vice, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reason-

able protection against harmful interference

in a residential installation. This equipment

generates, uses and can radiate radio fre-

quency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that inter-

ference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more

of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for

help.

In order to maintain compliance with FCC regulations, shielded

cables must be used with this equipment. Operation with non-ap-

proved equipment or unshielded cables is likely to result in interfer-

ence to radio and TV reception. The user is cautioned that changes

and modifications made to the equipment without the approval of

manufacturer could void the users authority to operate this equip-

ment.
NOTE: This device complies with Part 15 of the FCC Rules.
Operations subjected to the following two conditions (1) this device

may not cause harmful interference, and (2) this device must accept

any interference received, including that may cause undesirable in-

terference.

CAUTION: Regulations of the FCC and FAA

prohibit airborne operation of radio-frequency

wireless devices because there signals could

interfere with critical aircraft instruments.

CAUTION: If the device is changed or modified

without permission from RED, the user may

void his or her authority to operate the equip-

ment.

AUSTRALIA AND NEW ZEALAND STATEMENTS

RED declares that the radio equipment described in this document

comply with the following international standards.

IEC 60065 – Product Safety

RED declares digital devices described in this document comply

with the following Australian and New Zealand standards.

AS/NZS CISPR 22 – Electromagnetic Interference

AS/NZS 61000.3.2 – Power Line Harmonics

AS/NZS 61000.3.3 – Power Line Flicker

JAPAN STATEMENTS

This is a Class B product based on the

standard of the Voluntary Control Council

for Interference (VCCI) for information tech-

nology equipment. If this equipment is used

near a radio or television receiver in a do-

mestic environment, it may cause radio in-

terference. Install and use the equipment

according to the instruction manual.