Attach side media modules, Red dsmc media operation guide – RED DSMC MEDIA User Manual

Page 34

RED DSMC MEDIA OPERATION GUIDE

955-0047, REV-F | 34

ATTACH SIDE MEDIA MODULES

Follow the instructions in this section to attach any of the following modules to the DSMC BRAIN:

RED MINI-MAG Side SSD Module

Carbon Fiber RED MINI-MAG Side SSD Module

DSMC 1.8" SSD Side Module

DSMC 1.8" SSD Side Module (DRAGON)

Carbon Fiber DSMC 1.8" SSD Side Module (DRAGON)

WARNING: DO NOT attach the carbon fiber side SSD module using any screws except the red screws that are

provided. Using other screws, including the screws that come with the standard aluminum DSMC BRAIN or side

SSD modules, will strip the through holes and damage the panels of the carbon fiber BRAIN. For more informa-

tion, go to

WARNING: Damage to the DSMC, side SSD module, or other components of the DSMC system caused by mixing

carbon fiber components with non-carbon-fiber components is not covered under warranty, and may void the

warranty for both the BRAIN and the side SSD module. For more information, go to

REQUIRED TOOL: T10 Torx

driver

1. Place the side media module on the DSMC BRAIN, so that the mounting holes of the module align with the

screw holes of the DSMC BRAIN.

2. Use a T10 Torx driver to tighten the four (4) screws by about two (2) turns in a cross pattern. DO NOT FULLY

TIGHTEN.
The screw types for the side SSD modules are listed below:

‒ Aluminum side SSD modules: Black M3x0.5 x 6 mm or M3x0.5 x 5.5 mm cap screws.

‒ Carbon fiber side SSD modules: Red M3x0.5 x 6 mm cap screws that come with the carbon fiber DSMC

BRAIN.

3. Tighten the four (4) cap screws evenly. DO NOT exceed 70 in-oz, or damage may occur.

WARNING: DO NOT OVERTIGHTEN.

4. Insert the SSD in the SSD slot on the back of the side media module:

‒ RED MINI-MAG module: Install the RED MINI-MAG.

‒ DSMC 1.8" SSD Side Module: Install the REDMAG 1.8" SSD.

NOTE: DO NOT attempt to insert the RED MINI-MAG in any DSMC 1.8" SSD Side Module, and do not at-

tempt to insert the REDMAG 1.8" SSD in any RED MINI-MAG module.

Tighten Screws