Proheat A4 - Manual (Page 11)

PROHEAT AIR A2/A4 INSTALLATION MANUAL 2-1
INSTALLATION
TOOLS & PARTS REQUIRED
• Protective wire loom where required
• Grommets
• Cable ties
• Electrical tape
• P clamps (metal or plastic)
• Multimeter
• Hacksaw
• Drill
• 1" (25 mm) Unibit or Step Bit
• 1" (25 mm), 3" (75 mm), or 3.5" (90 mm) hole saw
• Reciprocating saw
• Metric Wrenches 7mm, 8mm, 12mm, 17mm
• Metric Allen Keys 3mm
• Mounting templates (located at back of manual)
• Hot Air Duct
• Hot Air Vents
GENERAL CONSIDERATIONS
Environmental
• Proheat Air heaters are designed for mounting inside a vehicle or cargo area only.
• Although Proheat Air heaters are designed to operate over a very wide range
of environmental conditions, extreme temperature, humidity and altitude may
affect optimum performance.
Access for regular servicing
• Ensure the mounting location provides sufficient access for regular servicing
including access to the glow plug, cable harnesses, fuse and housing.
• It may be necessary to alter or relocate vehicle hardware that may interfere
with the heater installation or ease of service. Always check with the vehicle
owner before making any modifications.
• Fuel, power and air ducts should be located and secured in a manner that
allows easy removal of the heater or access to replacement parts.
• SeaStar Solutions is not responsible for additional time taken during warranty
or repair arising from awkward or difficult mounting locations. The Owner is
responsible for any extra time incurred due to access issues.
2.0
2.1
2.2
NOTICE
Other considerations will present
themselves depending on different
applications. For answers to questions
specific to your applications, please
contact your dealer or Proheat
technical assistance.
2.2.2
2.2.1