Hour clock – PRG Mbox Director User Manual v3.9 User Manual
Page 68
62
MBOX
®
DIRECTOR USER MANUAL
24-Hour Clock
Scenes can be played back using a 24-hour clock. In this case, the playhead will always follow the current time of day
during playback. If a longitude and latitude are entered, scene times can also be relative to the local sunset and
sunrise.
To enable the 24-Hour Clock, it must be selected as the Timecode Source at the General Preferences window. (Refer
to
To configure scene times relative to the local sunset/sunrise, a "sunset" or "sunrise" prefix should be added to the
timecode entry. For example:
+
"sunset-00:30:00:00" will recall the scene 30 minutes before sunset.
+
"sunset+06:00:00:00" will recall the scene 6 hours after sunset.
To enable 24-hour clock with sunrise/sunset:
Step
1. Open Preferences window and select General tab. (Refer to
Step
2. Click Timecode Source pop-up and select "24 Hour Clock" from list.
Step
3. At new window, enter local latitude and longitude values.
Step
4. At Scene List, click in timecode field for a scene.
Step
5. Type in one of the following:
sunset+
sunset-
sunrise+
sunrise-
Step
6. Enter offset from sunrise/sunset using the typical HH:MM:SS:FF format.