Philips FW48-37 - Manual (Page 9)

GENERAL INFORMATION SAFETY INFORMATION
Safety................................................... 6-7
Limited Warranty................................... 8
General Information.............................. 9
Preparations................................... 10-11
Remote Control....................................11
Controls........................................... 12-13
Operating the System.................... 13-14
Tuner......................................................15
Cassette Deck..................................16-17
CD Changer..................................... 17-19
Clock Setting.........................................20
Timer Setting........................................ 20
Maintenance.........................................21
Specifications....................................... 21
Troubleshooting Guide.................. 22-23
General Information
• The typeplate (which contains the serial number) is
located at the rear of the set.
• Recording is permissible if copyright or other rights of
third parties are not infringed.
1 All unnecessary packaging material has been omitted.
We have tried to make the packaging easy to separate
into three mono-materials:
- cardboard (box)
- expandable polystyrene (buffer)
- polyethylene (bags, protective foam sheet).
Please observe the local regulations regarding the
disposal of these packaging materials.
2 Your set consists of materials which can be recycled
and reused if disassembled by a specialized company.
Please follow local regulations on recycling your old
set.
3 Do not dispose of dead batteries with your household
waste. Dispose of batteries according to local
regulations.
4 Note: Switching off the standby mode overnight
(remove the AC power cord from the wall socket) will
save energy.
Accessories (Supplied)
Safety Information
- Remote control
- Batteries (2 xAA) for remote control
- Alvi loop antenna
- FM antenna wire
- AC power cord
Accessories (Recommended)
- Philips Magnavox FB 201 active subwoofer.
Before operating the system, check that the operating
voltage indicated on the typeplate (or the voltage
indication beside the'voltage selector) of your system is
identical with the voltage of your local power supply. If
not, please consult your dealer. The type plate is
located at the rear of your system.
When the system is switched on, do not move it
around.
Place the system on a solid base (e.g. a cabinet).
Place the system in a location with adequate
ventilation to prevent internal heat build-up in your
system.
Do not expose the system to excessive moisture, rain,
sand or heat sources.
Under no circumstances should you repair the unit
yourself, as this will invalidate the warrantyl
If the system is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense on the lens of the CD unit inside the
system. Should this occur, the CD player will not
operate normally. Leave the power on for about one
hour with no disc in the unit until normal playback is
possible.
Electrostatic discharge may cause unexpected
problems. See whether these problems disappear if you
unplug the AC power cord and plug it in again after a
few seconds.
To disconnect the system from the power supply
completely, remove the AC power plug from the
wall socket.