Philips FW48-37 - Manual (Page 15)

TUNER
Tuning to radio stations Storing Preset Stations
1 Press SOURCE (or TUNER on the remote control) to
select TUNER.
2 Press BAND to select the desired waveband: FM or
AM.
3 Press TUNING l«or^^l for more than one
second.
The display will show '5ERRCH' until a station with
sufficient signal strength is found.
• Repeat this procedure until the desired station is
reached.
• To tune to a weak station, briefly press TUNING
or until the display shows the right frequency
and/or when the best reception has been obtained.
You can store up to 20 stations in the memory. When a
preset station is selected, the preset number appears next
to the frequency on the display.
Automatic programming
1 Press BAND to select the desired waveband: FM or
AM.
2 Press AUTO PROGRAM for more than one second to
start the automatic programming.
PBOBiwM flashes and 'flUTD' is displayed.
-* Every available station will be stored automatically.
The frequency and preset numberwill be displayed
briefly.
— It will stop searching when all the available stations
are stored or when 20 preset stations are stored.
• You can cancel the automatic programming by pressing
AUTO PROGRAM; TUNING or M-l ; PRESET
T or A: or BAND.
Note:
If you want to reserve a section of preset numbers, for
example preset numbers 1 - 9, select preset 10 before
starting automatic programming. Now only the preset
numbers 10 to 20 will be programmed.
Manual programming
1 Press AUTO PROGRAM for less than one second.
PROGRM.t flashes on the display.
2 Press BAND to select the desired waveband: FM or
AM.
3 Press TUNING l^^or^^l to tune to the desired
frequency.
4 Press PRESET T or A to select a preset number.
5 Press AUTO PROGRAM again.
PROGRAM disappears, and the station is stored.
• Repeat the above procedure to store other preset
stations.
Tuning to Preset Stations
• Press PRESET T or A (M or M on the remote
control) to select the desired preset number.
The preset number, frequency and waveband appear
on the display.
15