Philips FW48-37 - Manual (Page 18)

CD CHANGER
I
• To load the third disc, press the corresponding 3 CD
DIRECT PLAY button of the empty tray.
The CD changer will rotate until the empty tray is at
the right hand side and is ready for loading.
-* Playback will always start with the outer right disc
tray.
4 Press OPEN«CLOSE to close the CD compartment.
— The total number of tracks and the playing time of
the last selected disc will appear on the display.
The following display indications will help you to know
whether the disc trays are empty or loaded.
1 - indicates disc tray 1 is empty.
Ci2> - indicates disc tray 2 is loaded with a disc.
► - indicates disc tray 3 is the current or
selected disc tray.
Playing a Disc
1 Press PLAY«PAUSE (or ► on the remote control) to
start playback.
— The disc tray, track number and elapsed playing time
of the current track appear on the display.
• To interrupt play, press PLAY«PAUSE.
— The playing time flashes.
• To resume play, press PLAY»PAUSE again (or ► on
the remote control).
2 To stop play, press STOP*CLEAR (or ■ on the remote
control).
Note:
All the available discs will play once, then stop. When the
CD has stopped playing, the set will switch to the standby
mode automatically after 15 minutes if no button is
pressed.
■ a::
When the CD tray is closed,
you can play a CD directly
by pressing the 3 CD
DIRECT PLAY (1 - 3) buttons on the
set (or DISC button on the remote control). The CD player
will stop at the end of playback of the selected disc.
Selecting a desired track
Selecting a desired track when piayback is stopped
1 Press PREV or NEXT (M or M on the remote control)
until the desired track appears on the display.
2 Press PLAY»PAUSE (or ► on the remote control) to
start playback.
— The selected track number and elapsed playing time
appear on the display.
18