OmniSistem Sky Scan - Manual (Page 10)

To clean simply turn OFF the Sky-Scan unit by removing the AC input. Dampen a high quality cotton swab
with rubbing alcohol. In a swiping motion while rolling the cotton swap make a sweep of the entire surface of
the mirror. Then using the dry end of the cotton swab repeat the motion to eliminate the alcohol from the
surface of the mirror. Repeat as needed.
WARNING - DIRECTLY SHOOTING FOG INTO OR IN CLOSE PROXIMATY TO THE SKY-SCAN MAY
VOID WARRANTY.
1. Follow Instructions
All set-up and operating instructions should be followed for the safe operation of your scanning system.
2. Power Source
Operate this system only with the type of power supply listed on the products AC input. Never by-pass
grounding plugs as these have been provided for safety.
3. Objects and Liquids
Do not push objects into the unit through any openings as they may touch dangerous voltages, which may
result in fire or electrical shock. Do not spill liquids of any kind into the unit.
4. Servicing
Do not attempt to service this system yourself as opening the unit can expose you to dangerous voltage.
Only Qualified OmniSistem technicians should perform Service. Opening or removing the cover will void the
warranty.
5. Damage Requiring Service
• Immediately unplug the unit from the receptacle.
• Any damage requiring service as stated above must be reported immediately to
OmniSistem Lights and Effects and an RMA# will be issued.
• The product must be returned in its original packaging.
• Return the unit with ALL components and cables.
• Any damage that occurs due to inappropriate packaging will be repaired at your expense.
6. Laser Safety
Laser can pose an extreme hazard to the eyes and skin!
• NEVER expose eyes by looking directly into the beam no matter what the output level.
• NEVER uses eyes to align the beam by looking directly into the aperture.
Sky-Link – Sky-Scan – Safety 11.0