Oakworks 1922-01 Table Warmer - Manual (Page 2)

800.558.8850
www.oakworks.com
Operation & Controls
1. Turn table warmer on.
• Insert table warmer plug into the wall outlet.
• Press “ON/OFF” button and hold for 2 (two) seconds. Heating indicator will
appear on upper left side of screen.
2. Set controller temperature
• A thermometer mark will be present at the top of screen.
• Adjust “+” or “-” to chose your prerred heating temperature.
• Available temperature range is 86°F - 130°F.
Note: some controllers can go up to 135°F
3. Set heating time.
• Press the “ SELECT” button once and the clock icon will appear at the top
of the screen.
• Adjust “+” or “-” to choose the preferred amount of heating time. Available
time range is 1 minute (E-01) to 99 minutes (E-99).
4. Locking your settings
• Press and hold the “LOCK” button for 2 (two) seconds. This will lock the set
heating temperature and time. Lock indicator will appear on screen.
• Press and hold the lock button to unlock.
5. Obtaining current status
• Press the “STATUS” button once to obtain the actual, current temperature
and current heating time (if previously set).
6. Turn table warmer off.
• Press and hold “ON/OFF” button for 2 (two) seconds to turn controller off.
Temperature
Adjustments
+
-
!
126ºF
ON/OFF
+
-
Clock Icon
+ -
E-30
Status
+ -
103ºF
10:58
ON/OFF
+ -
+ -
Lock Icon
126ºF
E-30
1 1 1 1 1
2 2
3 3 3 3 3
4 4
5 5 5 5 5
6 6 6 6 6
Cleaning & Storage
• When storing, fold the table warmer loosely,
avoiding sharp bends and creases in the heating
elements.
• DO NOT roll the table warmer
• DO NOT store objects on top of the table warmer
• DO NOT dry clean. Chemicals can damage the
insulation and the cover of the heating unit.
• DO NOT iron.
• DO NOT machine wash or dry.
To Clean:
1. Before cleaning, make sure the hand control is
set to the OFF position.
2. Disconnect the electrical cord from the power outlet.
3. Spot clean by wiping the soiled area with luke
warm water and a neutral detergent or mild
soapy solution.
4. Wipe again with clean water.
5. Blot away excess water by compressing the
wet area between two dry towels.
6. DO NOT allow water to drip on the control unit.
Drying:
1. Drape the table warmer over a clothes line
and drip dry.
2. Do Not use clothes pins or clamps.
3. Do Not dry with a hair dryer or heater.
4. When hanging make sure to position the
hand control so that no water will drip onto
the control unit.
pn MMINSH0006 rev. 01.06.09
Lock
Select