Casio KL-C500 - Manual (Page 23)

E-22
Important! Note that the millimeter sizes shown in the above table are ap-
proximations only. The actual size may be smaller, depending on the font you
are using.
The vertical character sizes you can use are automatically limited by the tape
width of the tape loaded in the label printer.
Direct specification of character sizes
You can specify the character size in points to any one of 14 sizes from 9pt to
119pt.
A character size change is indicated on the display by a character size mark.The
following table shows the 14 character sizes that are available.
Character size (point) Actual Size (mm)
9pt 3mm
12pt 4mm
14pt 5mm
17pt 6mm
20pt 7mm
26pt 9mm
34pt 12mm
43pt 15mm
51pt 18mm
59pt 21mm
68pt 24mm
Character size (point) Actual Size (mm)
85pt 30mm
102pt 36mm
119pt 42mm