Oakworks 121A Procedure Chair Rev.C - Manual (Page 9)

6
DIRECTIONS FOR USE
ARM REST USE
TO LOWER THE ARM RESTS
Push arm rest in lightly towards the center of the table,
then pull locking knob down towards the table base.
Fold arm rests down and under the table.
TO RAISE THE ARM RESTS
Grasp arm rest and rotate to the raised position. When
fully up, the arm rest will lock into position. Check that
the arm rest is locked by applying light outward pressure.
1. Fully lower the manual
adjustable foot rest to allow
access to the stirrup.
3. Fold out to fully open
position.
2. Grasp Stirrup handle &
pull out firmly while lifting
slightly. Pull fully out.
4. To rotate stirrup to the
desired angle, lift slightly
and move to the desired
position. There are 3
detent positions. Stop lift-
ing and move slightly left
or right for the nearest
detent position.
5. To reduce stirrup
length, lift the handle
slightly and push into
desired position. Stirrup
will automatically lock
into nearest detent posi-
tion. To store stirrups, lift slightly, rotate towards the middle of the table and
fold the foot rest down. Then lift slightly and push into the storage position.
RETRACTABLE FOOT RESTS (STIRRUP) USE
CAUTION Pinch Point - Keep fingers away from pinch point.
PAPER ROLL HOLDER
To load the paper, locate the two
paper holder support arms located
on the under side of back rest.
Insert rod through paper roll
and place rod into the holes in
the support arms.
Pull paper and thread through the
straps across the upholstered top to
keep in place.
Note: The paper “hold down” strap is attached with Velcro ® . This allows strap tension adjustment if necessary.