NORAC UC5-BC-FT02 - Manual (Page 20)

17
7 Module Installation
7.1 Control Module
1. Refer to Figure 1 and Figure 14.
2. Securely mount the control module (E01) in the cab or on the sprayer. Refer to the display
kit instructions to determine the best mounting location.
3. Connect the display terminal to the control module using the display CANbus cable. This
cable must be connected to the end of the control module with only one Deutsch connector.
4. Connect the existing power cable to one of the two CANbus connectors on the other end of
the control module.
5. Route cable C01 from the other CANbus connector towards the rear of the sprayer.
Figure 14: Control Module Mounting