NORAC 4467BC+4B - Manual (Page 20)

17
7. Route the other end of hose H78 to the
NORAC valve block, following existing
hoses. Connect it to the 6FORXR-6MORT
tee fitting (F10) in the “T” port of the
NORAC valve block.
8. Connect the disconnected “P” and “T” lines
to the tees (F10) installed in the “P” and “T”
ports on the NORAC valve block.
9. Connect one end of the hydraulic hoses
(H74) to the NORAC 3 rd station expansion
valve block’s “A” and “B” ports.
10. Route the other end of the hoses to the roll
cylinder previously installed.
11. Attach the hose connected to the “B” port
of the valve block to the rod end of the
cylinder.
12. Connect the hose connected to the “A”
port of the valve block to the cap end of the
cylinder.