NORAC 4467BC+4B - Manual (Page 13)

10
Figure 8: Target Rod Alignment (Side View)
11. When the target positions are correct
ensure all mounting bolts are tight, then
double-check the target locations to ensure
that they haven’t drifted out of position.
Some adjustment of the Sensor Roll
Bracket may be necessary to achieve
proper alignment.
12. Once alignment is correct, trim the top rod
so it is 1 inch past the edge of the sensor, as
shown above in
Figure 9: Sensor and Rod Alignment as
Viewed From Above
Spring Rod trimmed 1”
past edge of sensor.
Spring Rod trimmed just
past edge of sensor