NORAC 4467BC+4B - Manual (Page 11)

8
Figure 5: Typical Roll Control Install
3. Remove the rubber bumpers on both
ends of the roll frame (Figure 5).
4. Install the frame target (B09) onto the
parallel lift frame. The mounting bolt
should be close to the vertical member
of the frame facing forwards. See Figure
4 and Figure 5.
5. The frame target should be 41” (104cm)
from the bottom of the sensor as
shown in Figure 6.
The frame target (B09) should be
mounted to a frame member
that does NOT rotate with the
boom.
6. Install the spring target (B12) onto the
boom center section 16” (41cm) down
from the bottom of the sensor as
shown in Figure 6.
The spring target (B12) must be
mounted to a frame member
that does move with the boom.
Figure 6: Target Location
Remove the Rubber
Bumper
Sensor Bracket (B11)
Spring Target (B12)
Frame Target (B09)
Mount Frame
Target as close
to the vertical
member as
possible.