NORAC UC4+BC+SM1 - Manual (Page 21)

18
ROP
4.7 E LECTRICAL I NSTALLATION
1. Install the UC4+ Control Panel (E01) in
the cab of the sprayer. Mount the panel
where it will be clearly visible and
within easy reach of the operator.
A good spot to mount the UC4+ control
panel is on the right hand side of the cab
to the Roll Over Protection Bar. Four
pilot holes for the screws provided need
to be drilled to facilitate the control
panel mounting.
Another option is to purchase an adapter
for the flexible panel mount that has a
3/8" NC threaded stud on the end to bolt
through an existing mount. You can find
these at your local outdoor store as a
RAM mount part number RAM-B-236.
(http://www.ram-mount.com/)
Figure 19 – Control Panel Mounting
ROP