NORAC UC4+BC+SM1 - Manual (Page 16)

13
4.5 R OLL S ENSOR I NSTALLATION
Mount the roll sensors to the included
roll sensor brackets using the machine
screws and nylon lock nuts, as illustrated
in Figure 11.
The roll sensors must be mounted
tightly to the brackets.
Figure 11 - Mounting the roll sensor to
the roll sensor mounting bracket
When mounting the roll sensors, use the
following guidelines and refer to Figure 12.
a) The smaller the distance between A
and B in Figure 12, the better the
performance will be.
b) Ensure the roll sensors are sitting
relatively level when the sprayer
chassis and boom are level.
c) Both roll sensors must be mounted
with the circular AMP connector
facing towards the Right-Hand
Wing (when looking from the rear
of the sprayer).
Figure 12 - General Roll Sensor mounting location on a Trapeze style boom
Connectors towards
Right-hand Wing 