NORAC UC4+BC+NT3 User Manual

Page 23

Figure 18: Cable Configurations: C10, C01 and C04

2. Locate the 16-pin AMP connector

attached to the sprayer’s joystick and

connect the 16-pin AMP tee connectors
of C10 between this connection.

3. Connect the 3-pin power connector

from C10 to the power bar on the right
hand side of the cab.

4. Connect the remaining 16-pin AMP

connector and one end of the UC4+
trunk cable (C01) to the UC4+ Control
panel.

Ensure the UC4+ control panel’s

power is off for the remainder of
the installation (bottom of switch
pressed IN).

Figure 19: UC4+ Joystick Connection