NORAC UC4+BC+NT3 - Manual (Page 17)

14
4.5 R
OLL
S
ENSOR
I
NSTALLATION
Mount the roll sensors to the included
roll sensor brackets using the machine
screws and nylon lock nuts, as
illustrated in Figure 9.
The roll sensors must be
mounted tightly to the brackets.
Figure 9: Mounting the Roll Sensor to
the Roll Sensor Mounting Bracket
When mounting the roll sensors use the
following guidelines and refer to Figure
10.
a) Ensure the roll sensors are sitting
relatively level when the sprayer
chassis and boom are level.
b) Both roll sensors must be mounted
with the circular AMP connector
facing towards the Right-Hand Wing
(when looking from the rear of the
sprayer).
Figure 10: Mounting Guidelines