NORAC UC4+BC+JD6 - Manual (Page 29)

26
Figure 34: Junction Cable Connections (C12)
16. Connect 4-pin AMP connectors to the
sensors.
17. Connect the sensor branch cable (C02)
to the 4-pin AMP plug on C02B.
18. Route the sensor branch cable (C02) to
the wing and main sensors and connect
to the sensors. Follow existing cables
and/or hydraulic lines along the boom.
19. Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the
main section, parallel lift, and
FOLDING boom movement.
Figure 35: Cable Configurations: C01,
C02Bnd C02B