NORAC UC4+BC+JD6 - Manual (Page 13)

10
Exhaust clamps (B15 and B16)
can be used if mounting the
sensor brackets to a portion of
the boom with round tubing.
Figure 6: Low Profile Bracket
Mounted with Exhaust Clamps
Rainflaps are only installed in the
wing sensor brackets.
4. Insert one side of the rainflap rod into
the pre-bent hinge tab on the sensor
bracket. (Figure 7)
Figure 7: Rainflap Rod in Pre-Bent
Hinge Tab
5. Align the other side of the rainflap rod
with the unbent hinge tab. (Figure 8)
Figure 8: Align Rainflap Rod
6. Bend the hinge tab inward over the
rainflap rod until the hinge tab fits
securely in the detent groove on the
backside of the sensor bracket. (Figure
9)
Figure 9: Bend Rainflap Hinge Tab
7. Ensure the rainflap actuates smoothly
when the bracket is turned upside down
and returns to the open position when
the sensor bracket is returned to its
operating position (sensor pointing
downwards toward the ground).
Front