Carrier Miracool 260L - Manual (Page 14)

14
MAINTENANCE
LAMP REPLACEMENT
Remove lamp by rotating lamp 90 degrees to align
lamp pins with holder slots. Refer to Bi-Pin Fluores-
cent lamp Installation/Verification section on page 6.
CONDENSATE REMOVAL
The evaporator drain pan is located in the base of the
cartridge. In general, the condensate disposal system
is maintenance free.
CONDENSER
The condenser should be inspected periodically for
accumulation of debris, which should be removed. A
vacuum cleaner or brush can be used to remove debris.
CABINET EXTERIOR
Cabinets should be cleaned with a solution of mild
soap and water or mild household cleaner. Do not use
caustic soap or abrasive cleaners, since these might
damage the cabinet finish. If stainless steel surface
becomes discolored, scrub by rubbing only in direction
of the finish grain. Do not use steel wool or rusting
may occur. Refer to Table 4.
INTERIOR SURFACE
The inside of the cabinet is coated with baked-on
epoxy. To clean, use a mild soap and water solution or
mild household cleaner.
Before proceeding with replacement, disconnect
electrical service. Failure to unplug unit could result
in serious personal injury or death.