Microtel CellStat v.2.10 - Manual (Page 24)

MICROTEL CellStat
TM
22
Checking System Status
CellStat
TM
allows easy checking of system status and capability. Spoken reports of your
entire remote-monitored system can easily be generated, or SMS text message status
reports can be retrieved via the dialer’s built-in cellular capability.
A spoken system status report can be received from the dialer by entering the following
command from a touch-tone telephone either locally, or remotely after answering or
calling the dialer. The dialer will speak a voice message of system name and current
alarms or normal status. It will also report the current cellular signal strength, remaining
balance in the prepaid cellular account, temperature, and local output state IF the local
output has been manually controlled.
z System Status Gives a complete status of all points monitored by the dialer
*00 Report system status
Example- Command:
*00
Response: MICROTEL CELLSTAT Channel one normally closed
digital input in alarm. Cellular power is normal. Cellular
balance is one one point six four dollars ($11.64).
Temperature is seven eight degrees. The local output is
open.
Alternatively, an SMS Text Message report of system status can be retrieved by sending
the following text message from a mobile phone with text message capability:
“stat” Report system status via SMS Text Message
Example- Command: “Stat”
Response: “CellStat(TM)
Channels in Alarm:1,
Cellular power: normal.
Cell balance: $11.64
Temp: 78 (74, 78) F
Output: OPEN”
NOTE: When entering the “Stat” text message, do NOT type the “” marks.
NOTE: Display formatting on your mobile phone may be slightly different.
Using the Log-Stat™ Web-based Application