Microtel CellStat v.2.10 User Manual
Page 20
MICROTEL
CellStat
TM
18
Example- Command:
**0412
Response: The snooze delay is one two hours.
z Firmware Version
*05 Report
Firmware
Version
Response will play back all resident vocabulary, then speak “Cell Stat version number
is two point one zero”, where “ two point one zero” is the current firmware version
(e.g. 2.10).
z Control Local Output Manual control of local output contacts. This command
will allow the single local output contacts to be manually opened (de-energized),
closed, or configured as a summary alarm output (default).
*06
Review local output configuration
**06 0/1/2
Configure/Control local output
Example- Command:
**060
Response:
The local output is closed.
Example- Command:
**061
Response:
The local output is open.
Example- Command:
**062
Response:
The local output is fault status.
Configuring Fault Inputs
The CellStat
TM
features true modularity—Fault input channels operate completely
independently of each other. Using the following commands, each Fault Input in your
dialer can be configured to operate uniquely to satisfy your application requirements. For
each Fault Input, record a voice message, program an alarm integration delay, define the
input channel’s normal (non-alarm) state, and comfigure whether cleared alarms should
be reported.
z I/O Channel Voice Name An individual I/O channel’s spoken voice name.
*c1
Play I/O channel c voice name
**c1~
Record I/O channel c voice name
NOTE: User cannot record a voice message for the Power Fault channel 5
Sample Message- Channel one normally open digital input.