MF Digital DIRECTOR CD/DVD Combo Series (Rev: 08/01/02) - Manual (Page 75)

DIRECTOR Series Operator’s Guide Document Revision: 0802
Page 74
General Options
Vertically along the left side of the Job tab are a series of ten check boxes:
Copy, Verify, Print, Print First, Simulate, Archive, Align, Protect,
SmartGuard Media and DVD. The first step in creating a job is to set the
general options so as to define which operations the DIRECTOR will perform
when the job is submitted for production.
•
Check or uncheck the option boxes to enable or disable the production
options needed for your job:
General Options:
Copy When checked, the CDs in the submitted job will be
recorded using the disc image file selected in the
IMAGE field.
Verify When checked, the CDs in the submitted job will
automatically be compared against the source files
after recording is completed.
Print When checked, the CDs in the submitted job after
recording will be printed with the disc label selected
in the LABEL FILE field.
Print First When checked, the CDs in the submitted job before
recording will be printed with the disc label selected
in the LABEL FILE field.
Simulate When checked, the CDs in the submitted job will not
be recorded.
Archive When checked, an existing CD is saved to the hard
drive as a physical image file for later recording. This
option is used for duplicating existing CDs.
Align When checked, CDs will be placed on the optical
aligner so that the disc may be oriented relative to the
alignment mark. This is used for over-printing silk-
screened discs.
Protect When checked, the CDs in the submitted job will be
recorded so that they are copy protected using the
copy protection file selected in the Copy Protection
DIRECTOR systems equipped with Pioneer DVD-R drives do not
support MediaFORM SmartDRIVE features.
Note: