Malone MPG201 - Manual (Page 2)

Installation Instructions - MPG201, 202, 203 Universal Cross Bar
MALONE
R
4
5
6
. Push the Rubber Spacer Block up each
foot until the top flat section is formed
around the top of the foot.
See image 5.
. Smaller sized factory side rails require the
Rubber Spacer Blocks. To attach, insert a
Rubber Spacer Block to the inside foot of
each tower system. See image 4.
. Insert the Installation Wrench and tighten
the bolt clockwise until the feet hold the
cross bars firmly in place. Apply pressure
to confirm that no movement of the Cross
Bars can be felt. Raise the lock plate and
lock with Key. See image 6.
Malone Universal Rack Guidelines
. Never assume a cross bar will fit. Always refer to Malone’s Fit Guide for proper, correct and approved vehicle fit.
. Confirm that all bolts and locks are firmly secured prior to transport. Periodically check the load during transport.
. Do not continue to use the product if excessive corrosion, deformity or any mechanical defect is detected.
. Check local and state laws governing projection of objects beyond the perimeter of the vehicle.
. Locks must be turned periodically and lubricated to ensure smooth operation. Use of a dry lubricant is recommended.
. Malone locks are designed to deter vandalism and theft but should not be considered theft proof.
. Obey all posed speed limits and traffic cautions. Adapt your driving for the load being transported.
. Do not use Malone cross bars for purposes other than what they were designed for.
. Not for use on trailers or any other modes of transport other than vehicle rooftop transport.
. Failure to follow these guidelines will void the warranty.