Longshine LCS-K916 - Manual (Page 12)

11
Figure 13: Buzzer setup hot key
Figure 14: Auto-scan hot key
Channel Name
Channel Number
Indicate now is Scan Mode
Figure 15: Auto-scan Banner
Note: With cascading 3 layers, you can select last layer directly;
Example: press twice, then D2D5D7, and :
D2 : layer 1 channel 2 links to
D5 : layer 2 channel 5 links to
D7 : layer 3 channel 7 selected
Note: You can also select active channel of cascade chain in OSD menu. Move the indicator bar to the
chanel to switch by using , or , and then press to switch
to the target port. Please refer section 7.2.2 Channel select to cascade port.
6.5. Buzzer sound Disable / Enable
Press twice, then and . The buzzer sound will be disabled / enabled
alternately. The buzzer sound default setting is ON.
→→→
Note: You can also enable/disable buzzer sound by pressing in OSD main menu. Please refer
section 7.3.6 Setup in OSD - Sound.
6.6. Auto-Scan Function
When you enable Auto-Scan function by pressing twice, then and . The KVM
Switch will shift through all the ports and display them on the monitor.
The mouse and keyboard will be disabled under this mode. This is necessary to prevent errors such as
erratic movement and wrong characters to display when using the mouse or keyboard in accident.
6.6.1. Start auto-scan function
→→→. The auto-scan banner will be shown to indicate the
scanning channel.