LABEC M-TIT-5 - Manual (Page 31)

In starting status, press ‘View’ button in menu, select viewing method you need, press ‘Enter’ button
to view relative titration data. Displayed as follows
Diag.38 Display when select viewing method
View Titration Mode Set Calibrate
Titration panel READY + K 10/21
Feed
Clean
Titration
Exit
Enter
View
View current data
View stored data
8.1 Handling of Current Data
When titration finished, meter will save current titration data, user can view the titration data
again
Store Mode Concentration End point Print About
Diag.39 Display of viewing current data
One the top is menu including ‘Store’, ‘Mode’ (if there is end point), ‘Concentration’ (if there is
end point), ‘End Point’, ‘Print’, ‘About’ and ‘Close button’. In the middle is titration curve area,
user could view and handle titration data. Perpendicular line is indicating line, user could move it to
a certain position and view or hand the titration data at this position. Moving could be done by
pressing ‘﹤’, ‘﹥’, ‘1﹤’, ‘﹥1’.
30