LABEC M-TIT-5 - Manual (Page 30)

7.5.3 Next Adding Volume Parameter
Next adding volume parameter is next adding volume after adding volume this time, this
volume can be reset after anyone adding.
7.5.4 End Volume Parameter.
The same as End Volume Parameter in Pre-Titration
When all the above setting finished, press ‘Start Titration’ button to enter into Manual
Titration. After pre-adding volume, the meter will wait for user’s next operation. User can
press ‘Add’ button to add titrant of set volume, or to press ‘Set Adding Volume’ button to set
new volume, press ‘End’ to stop titration.
0.130mL
Add
End
Set Adding
Volume
Manual Titration>Titration Panel READY 00:14:08
Diag.37 Manual Titration
8. Handling of Titration Data (including Viewing, Storing, Printing and Generating Mode)
The meter provides two viewing method:
a. Allow user to view the titration data again after titration.
b. User could view stored titration data
Note: a. In the process of the titration, if user stops titration soon which cause the titration data of
actual record is less (less than 3), user is not able to view current titration data, if user did not store
titration data, he also cannot view the stored data.
b. After each titration, previous titration data will lose automatically and user is not able to view
previous titration data
29