Kenton Pro-2 - Manual (Page 4)

_________________________________________________________________
Trimmer adjustments for Channel A & B
_________________________________________________________________
CV INIT (range approx 2 octaves)
- tunes the converter to the synth.
CV SCALE (range approx 20%)
- adjusts the scale of the converter to match the synth. When the converter leaves the factory, this is
set to the standard 1 volt per octave, but some synths may require some adjustment of this control if
the octaves are out of tune with each other.
PITCHBEND (range approx 0 to 1 octave)
- adjusts how much pitchbend is integrated into the CV output. You can set this control to give you
any required amount of pitch- bend from zero to 1 octave.
AUX 1 (range 4 to 14 volts)
- adjusts the maximum voltage available from the AUX 1 jack socket for Channel A - in other words
the maximum voltage available when the source controller for AUX 1-1 is at maximum. This
adjustment is provided as different synths require different voltages.
AUX 2 (range 4 to 14 volts)
- adjusts the maximum voltage available from the AUX 2 jack socket for Channel A - (see AUX 1
above).
_________________________________________________________________
Tuning in your PRO-2 & analogue synths
_________________________________________________________________
It may be that your synth is slightly out of tune, so it will be necessary to tune the PRO-2 to your synth;
1, Tune your synth (when playing from its own keyboard) correctly with your digital synths first. Do this
by adjusting the tuning or pitch knob on your analogue synth whilst playing middle C on both synths.
(To do this, you may need to disconnect the analogue synth from the PRO-2).
2, Now, with the PRO-2 connected to the analogue synth, play middle C on your digital synth. Both
synths should sound. With a small flat blade screw driver, tune in the PRO-2 with your analogue synth
by adjusting the INIT trimmer on the front panel.
3, When your digital & analogue synths are once again in tune, play a key two octaves up on your
digital synth. Now adjust the SCALE trimmer till both synths are in
tune . The analogue synth should
now play correctly across it`s range from your master keyboard.