Kenton Pro-2 - Manual (Page 12)

_________________________________________________________________
INFO FOR CONNECTING PRO-2 TO VARIOUS MONO
SYNTHS
_________________________________________________________________
MINIMOOG KENTON PRO-2 ADDITIONAL INFORMATION
OSCILLATOR INPUT (1/4" jack) CV CHAN (A) The oscillator input on this synth is affected by the last
note played on the Minimoog keyboard
S-TRIG INPUT (Cinch-Jones) S-TRIG (A) See note 1 below re Cinch Jones connectors.
FILTER INPUT (1/4" jack) AUX 1 (A) See note 5 below re FILTER
LOUDNESS (1/4" jack) AUX 2 (A)
MOOG PRODIGY KENTON PRO-2 ADDITIONAL INFORMATION
KBD IN/OUT (1/4" jack) CV CHAN (A) EARLY MODELS HAVE NO CV, GATE OR FILTER
INPUTS FITTED AS STANDARD
(although we can fit them for you - see notes)
S-TRIG IN/OUT (1/4" jack) S-TRIG (A) Some Prodigy synths have the Cinch Jones connector
for s- trig input- see note #1
VCF IN (1/4" jack) AUX 1 (A) See note 5
MOOG ROGUE KENTON PRO-2 ADDITIONAL INFORMATION
CV IN (ring of 1/4" stereo jack) CV CHAN (A) See note 7 below for connections to ring of stereo jack
V-TRIG IN (ring of 1/4" stereo jack) GATE (A) Do not use the S-TRIG connection on this synth as it
sometimes causes unpredictable results
MOOG SOURCE KENTON PRO-2 ADDITIONAL INFORMATION
CV IN/OUT (ring of 1/4" stereo jack) CV CHAN (A) See note 7 below for connections to ring of stereo jack
S-TRIG IN/OUT (ring of 1/4" stereo jack) S-TRIG (A) If the level 2 EXT TRIG on the Source is set to off, all
external triggers are defeated.
ROLAND SH-101 KENTON PRO-2 ADDITIONAL INFORMATION
CV INPUT (3.5mm jack) CV CHAN (A) We can fit additional filter and modulation control
sockets to the SH-101
GATE INPUT (3.5mm jack) GATE (A)
EXT CLK IN (3.5mm jack) ARP CLK will run the internal sequencer in time with MIDI - do not use
at the same time as the CV & gate
SEQUENTIAL PRO-ONE KENTON PRO-2 ADDITIONAL INFORMATION
CV IN (1/4" jack) CV CHAN (A)
GATE IN (1/4" jack) GATE (A)
FILTER IN (1/4" jack) AUX 1 (A) See note 5
KORG MS-20 KENTON PRO-2 ADDITIONAL INFORMATION
VCO 1+2 CV IN (1/4" jack) Hz/V CHAN (A) Requires the PRO-2 Hz/V option to be fitted
TRIG IN (1/4" jack) S-TRIG (A) Use the S-TRIG output of the PRO-2
ANY OTHER (1/4" jack) AUX 1 (A) There is much facility for control on the MS-20
ANY OTHER (1/4" jack) AUX 2 (A)
KORG MONOPOLY KENTON PRO-2 ADDITIONAL INFORMATION
CV IN (1/4" jack) CV CHAN (A) ADJUST THE PRO-2 CV INIT TRIMMER FOR THE
APPROPRIATE CHANNEL TO 1 OCTAVE HIGHER THAN
THE FACTORY DEFAULT
TRIG IN (1/4" jack) GATE (A) SET TRIG POLARITY OF THE MONOPOLY TO +15v
VCF fcM IN (1/4" jack) AUX 1 (A) ADJUST THE PRO-2 AUX 1 TRIMMER TO +5 VOLTS
PORTA (1/4" jack) AUX 2 (A) ADJUST THE PRO-2 AUX 2 TRIMMER TO +5 VOLTS
[works inverted] (switches portamento on & off)
ARPEGGIO TRIG IN (1/4" jack) ARP CLK
YAMAHA CS-30 KENTON PRO-2 ADDITIONAL INFORMATION
KEY VOLT IN (1/4" jack) Hz/V CHAN (A) Requires the PRO-2 Hz/V option to be fitted