Kenton Pro-2 - Manual (Page 2)

_________________________________________________________________
INTRODUCTION
_________________________________________________________________
Congratulations on your purchase of the Kenton Electronics PRO-2 dual channel MIDI
to CV converter, which has been designed to give you maximum flexibility, whilst
maintaining ease of use.
The converter has two completely independent sections - one called Channel A and
the other Channel B - do not confuse these with the MIDI channels - each of
Channel A & B can be operated independently from any MIDI channel.
Additionally, you can have a Wasp port fitted, to run an EDP Wasp synth, and a KADI
port, to allow you to control the notes of some drum machines (TR-808/606,
CR78/8000).
_________________________________________________________________
The BARGRAPH display
_________________________________________________________________
The Bargraph display is used in conjunction with the SELECT OPTION push button. The bar which is lit
(or unlit for inverse display) indicates which option is current. The current option value is displayed in
the dual 7 segment display window and can be edited using the INC & DEC buttons.
A normal bargraph display (one bar lit) indicates that the option is from the Group I list (i.e. MIDI
channel A etc.). An inverse bargraph display (all but one bar lit) indicates that the option is from the
Group II list (i.e. Note priority A etc.).
_________________________________________________________________
THE DUAL 7 SEGMENT DISPLAY
(also referred to as the Window)
_________________________________________________________________
When displaying letters, & numbers from 0 to 99, you will see the digits as you would expect.
When displaying numbers above 99, the following format is used :-
a dash " - " at the bottom of the left-hand display = 100+
a dash " - " in the middle of the left-hand display = 110
+
a dash " - " at the top of the left-hand display = 120+