Compaq R6000 - Manual (Page 60)

Configuration 4-5
Heat Sink Over Temperature
Input AC Over Voltage
Input AC Under Voltage
Input AC Over or Under Frequency
Output Overload
Inverter Fault
Battery Low
Utility Not Present
Battery Totally Discharged
UPS on Battery
Load Power Off
Battery Test Failed
Site Wiring Fault
Battery Data
Battery Charge
Firmware Version
Control Board
Communication Board
Load Control
Display Test
System Setup
Set Hardware Configuration
Load Segments
Battery Setup
Set Language
Set Alarm Horn
Set Password
Set Sync Range + Hertz
Communications Setup
Serial Port 1
Serial Port 2
Set Voltage
Set Site Fault
Set Sleep Mode
Status
Main Menu
→ Status
The first choice on the Main Menu is “Status.” Pressing the Enter button when
“Status is displayed leads to the following sub-menu choices:
UPS Status + Load Segment status
This shows that the UPS has detected no problems. In this example, load
segments 1, 4 and 5 are ON. Segments 2 and 3 are OFF.
System Normal