Canon DR-4080U - Manual (Page 4)

2
For your safety please read the following text carefully. (For United Kingdom only)
This appliance is supplied with a moulded three pin mains plug for your safety and convenience.
A 5 amp. fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement
fuse has a rating of 5 amps. and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark
or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover you must
ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used
until a replacement cover is obtained. A replacement fuse cover can be purchased from your local Canon
Dealer.
If the fitted moulded plug is unsuitable for the socket outlet in your home then the fuse should be re-
moved and the plug cut off and disposed of safely.
There is danger of severe electrical shock if the cut off plug is inserted into any 13 amp. socket.
If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult
a qualified electrician.
WARNING:
This appliance must be earthed.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code.
Green-and-Yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows.
The wire which is coloured Green-and-Yellow must be connected to the terminal in the plug which is
marked with the letter E or by the Earth symbol
or coloured Green-and-Yellow.
The wire which is coloured Blue must be connected to the terminal in the plug which is marked with the
letter N or coloured Black.
The wire which is coloured Brown must be connected to the terminal in the plug which is marked with
the letter L or coloured Red.
How to replace the fuse:
Open the fuse compartment with a screwdriver and replace the fuse.
FUSE