Setting up the scanner – Canon DR-4080U User Manual

Page 22

Number, mode and

Content

default display

15 Load scanning settings

Loads the scanning settings from Memory 1 or Memory 2.

1 5 . L o a d

S e t t i n g

D e f a u l t

Default Memory 1 Memory 2

Use the or key to select Memory 1 or Memory 2. The saved settings
for scanning are enabled with the “Save Scanning Settings” execution.

If other settings have been saved in another memory, you can change
the settings easily during scanning.

This setting is not changed even if the power is switched off and on.

If “Default” is selected, all the saved scanning settings will be reset to
their default values.

Note:

After changing settings 01 to 13, execute “14 Save scanning settings” to save the changes. If the

settings are not saved before the scanner is switched off, all the changes will be cleared and the previous
settings will be restored.

Setting up the scanner