Canon DR-4080U - Manual (Page 10)

8
General Location
• Make sure there is enough space around the scanner as shown in the illustration.
250 mm (9.8")
300 mm (11.8") 200 mm (7.9")
• The scanner should not be exposed to direct sunlight. If this is unavoidable, install heavy curtains on the windows.
• The area around the scanner should be free of dust, fumes, and water vapor.
• The area around the scanner must be well ventilated to allow using the volatile roller cleaning paper and paper
roller cleaning fluid.
• Never place the scanner near running water, a heat source, or in an area like a laboratory exposed to volatile,
corrosive, flammable chemicals like ammonia, acetone, benzene, etc.
• Set up the scanner in a room that is well within a comfortable range of temperature and humidity, and not subject
to rapid changes in temperature or humidity.
Room temperature
15°C to 30°C (59°F to 86°F)
Relative humidity
20% to 80% RH
• Place the scanner on a clean, flat, stable surface free of vibration and shocks.
• Never place the scanner near office equipment or an appliance that generates a strong magnetic field. The elec-
trical “noise” from such a device could interfere with operation of the scanner.
• Never attempt to place or operate the scanner in a vertical position.
• To avoid poor performance caused by static electricity, never operate the scanner on top of a carpet.
Power source
• Use a power source with a voltage level that does not vary more than 10% from the voltage level marked on the
name plate (located on the back side of the scanner).
• Set up the scanner close to an independent power source. Do not plug the scanner power cord into a power outlet
that is shared by other devices or equipment.
• Keep the area around the power outlet free of obstructions in case you need to unplug the power cord quickly in an
emergency.
Power cord
• Use only the power cord supplied with the scanner and do not use an extension cord.
• Do not use a line conditioner, transient suppressor or surge protector.
• Never bundle the power cord or wrap the power cord around an object like a table leg.
• Keep the power cord free. Never place heavy objects on top of the power cord.
Before you begin