Cabletron Systems 6H203-24 - Manual (Page 35)

Installing the Module into the 6C105 Chassis
Installation 3-3
Figure 3-1 Installing an Interface Module
5. Examine the module for damage. If any damage exists, DO NOT install the module.
Immediately contact Cabletron Systems. Refer to
Section 1.2 for details.
!
CAUTION
To prevent damaging the backplane connectors in the following step, take care that the
module slides in straight and properly engages the backplane connectors.
Ensure that the top plastic locking tab lines up with the desired slot number located on
the front panel of the chassis. Refer to
Figure 3-1 .
1 2 3 4 5 PS1 PS2