Philips AZ 6825 - Manual (Page 8)

RESUME HOLD
RESUME: Resuming playback
This function is very useful when the CD player is connected to the cigarette lighter in your
car. If you switch off the car ignition, the CD player is also switched off. If you switch on the
ignition again, playback will continue from the place where it has been stopped
• Slide the RESUME/HOLD switch to the RESUME ON position during playback.
• Stop playback by pressing the STOP ■ key.
• Press the PLAY/PAUSE No key to resume playback. Playback will start from the position
where it has been stopped.
• To switch off the RESUME function, slide the switch to the OFF position.
Notes:
1. If the power has not been interrupted, the CD player will resume playback exactly from the
position where it was stopped.
2 If the power was interrupted while resume was switched on, the CD player will resume
playback from about the position where it was stopped with an accuracy of+or -20
seconds.
HOLD: Deactivating all CD-player keys__________________________ _
Use this function when carrying the player with you. The CD-player buttons are then inopera­
tive and the lid cannot be opened. Now, playback of a CD will not be interrupted when a
button is accidentally touched.
• To switch on the HOLD-function, slide the RESUME/HOLD switch into the RESUME/HOLD
ON position.
• To switch off the HOLD function, slide the switch to the OFF or RESUME ON position.
Notes:
1. In the HOLD position the RESUME function is automatically activated.
2 If HOLD is switched on and you try to activate the CD player from the standby mode, the
set will not start and the display shows 'HOLD'.
3. AZ6325 only: The HOLD switch on the remote control SBC 6225 makes only the remote
control buttons inoperative and does not affect the CD player buttons.