Philips FW830C - Manual (Page 25)

mma
SLEEP TIMER
Notes:
- During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically
- When a power interruption occurs, the
clock setting is erased.
Setting the Timer
• The system can switch on to CD,
TUNER, or TAPE 2 mode automatically
at a preset time. It can serve as an
alarm to wake you up.
® Before setting the timer, make sure the
clock is set correctly.
® Thetimer will always be switched on
once it is set.
• The volume of the timer will start to
increase from the minimum level
until the volume level before the set
is switched to standby mode.
1 Press and hold CLOCK/TIMER for more
than 2 seconds to select timer mode.
"Rri IE: ■ 00" or the last set timer
starts flashing. The
timer flag
flashes.
The last selected source is lit while
other available sources are flashing.
2 Press CD, TUNER or TAPE to select the
desired source.
• Before selecting CD or TAPE, make sure
a CD or tape is loaded in the CD tray or
tape deck 2.
3 Press ◄◄ or ►► to set the hour for the
timer to start.
4 Press M or M to set the minute for
the timer to start.
5 Press CLOCK/TIMER to store the start
time.
The timer is now set.
The TIMER flag remains on the display.
• At the preset time, the timer will be
activated.
^ The selected source will be played.
Notes:
- During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically
- If the source selected Is TUNER, the last
tuned frequency will be switched on.
- If the source selected is CD, playback
will begin with the first track of the last
selected disc. If the CD trays are empty,
the TUNER will be selected instead.
- If the source selected is TAPE, and if the
preset time is reached during high
speed dubbing, the TUNER will be
selected instead.
To switch off the TIMER
1 Press CLOCK/TIMER for more than 2
seconds.
2 Press ■ on the system to cancel the
timer.
The timer is now switched off.
^ The display will show " "and the
TIMER flag disappears.
To start the TIMER again (for the same
preset time and source)
1 Press CLOCK/TIMER for more than 2
seconds.
2
Press CLOCK/TIMER again to store the
start time.
The timer is now switched on.
The TIMER flag appears on the display.
Sleep Tinier (only on remote control)
This feature allows you to select a length
of time after which the system will switch
to the standby mode automatically.
• Press SLEEP TIMER on the remote
control repeatedly to select a period of
time.
The selections are as follows (time in
minutes):
^ "SLEEP XX" or "OFF" will be
displayed. ".X.X" is the time in
minutes.
• When you reach the desired length of
time, stop pressing the SLEEP TIMER
button.
After this amount of time passes, the
system will switch to the standby
mode.
To switch off the sleep tinier
• Press SLEEP TIMER repeatedly until
"OFF" is displayed, or press the
STAiDBY®Oi button.
25