Philips FW830C - Manual (Page 14)

CONTROLS OPERATING THE SYSTEM
VEC
to select the desired sound effect:
HALL, DISCO, CONCERT, CLUB,
CINEMA or ARCADE.
DYNAIVfIC BASS BOOST (DBB)
to select a bass boost level or to
switch off bass boost.
TAPE DECK 1
OPEN
to open tape deck 1.
REPEAT
to repeat a CD track, a disc, or all the
available disc.
SHUFFLE
to play all the available discs and their
tracks in random order.
SLEEP TIfVlER
to switch the system to standby mode
at a selected time period.
(!)
to switch the system to standby mode.
Notes for remote control:
-
First select the source you wish to
control hy pressing one of the
source select keys on the remote
control (e.g. CD, TUNER, TAPE 1/2
orAUXj.
-
Then select the desired function
($^, M, H,etc.j.
Inserting batteries into the
Remote Control
• Insert the batteries (Type ROB or AA)
into the remote control as shown in the
battery compartment.
To avoid damage from possible battery
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type ROB or
AA batteries.
complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system. When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
- During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
- When the system is switched to standby
mode, the demonstration will resume
five seconds later.
for five seconds when the system is in
demonstration mode.
The demonstration will stop.
" " is displayed.
The system will switch to standby
mode.
About 5 seconds later, the system
will go into an energy saving mode
(< 2 watts). The low power
STANDBY ON LED will be lit.
Note:
- Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
14