Philips FW830C - Manual (Page 18)

CD
Loading the CD Changer
1 Press CD to select CD mode.
2 Press OPEN®CLOSE.
The CD carousel slides out.
3 Load a CD with the printed side up in
the right tray.
® You can load another disc in the left
tray.
• To load the third disc, press the DISC
CHANGE button.
The CD carousel will rotate until the
empty tray is ready for loading.
4 Press OPEN*CLOSE to close the CD
carousel.
The total number of tracks and the
playing time of the last selected disc
appear on the display.
Note:
- To ensure good system performance,
wait until the CD changer completely
reads the disc(s) before proceeding.
CD Direct Play
You can play a CD directly by pressing the
DISC 1, DISC 2 or DISC 3 button. The CD
player will stop at the end of playback of
the selected disc.
- A lit button indicates that a disc is
loaded in the disc tray.
18
Playing a CD
1 Press ► to start playback.
The disc tray, track number and
elapsed playing time of the current
track appear on the display.
The current track number will also be
flashing on the music calendar.
When a track has been played, the
track number will be erased from the
music calendar.
• To interrupt playback, press II.
^ The playing time flashes.
• To resume playback, press ► again.
2 To stop playback, press ■ .
Note:
-All the available discs will play once,
then stop.
Disc Change
You can change the outer two discs while
the third inner disc is stopped or is playing.
1 Press DISC CHANGE
The CD carousel slides out.
2 Replace the discs in the left and right
disc trays.
® If you press DISC CHANGE again
during playback, the CD will stop
playing.
The CD carousel will rotate until the
inner tray is rotated out and is ready
for loading.
3 Press OPEN®CLOSE to close the CD
compartment.
Selecting a desired track
Selecting a desired track when
playback is stopped
1 Press N or M until the desired track
appears on the display.
2 Press ► to start playback.
The selected track number and
elapsed playing time appear on the
display.
Selecting a desired track during
playback
® Press N or M until the desired track
appears on the display.
The selected track number and
elapsed playing time appear on the
display.
® If you press M once it will skip to the
beginning of the current track and play
the track again.
Searching for a particular
passage during playback
® Press and hold « or ►► until the
desired passage is located.
The volume will be reduced.
® Play returns to normal when « or ►►
is released.
Programming Tracks
Programming tracks of a loaded CD is
possible when playback is stopped. The
display will indicate the total tracks stored
in the program. Up to 40 tracks can be
stored in the memory in any order. When
40 tracks are stored and you attempt to
store another track, the display will show
1 Load the desired discs in the disc trays.
2 Press PROGRAM to start programming.
The PROGRAM flag starts flashing.
It will cancel any previously selected
repeat mode.
3 Press the CD (CD 1 ®2®3) button to
select the disc.
4 Press N or M to select the desired
track.
5 Press PROGRAM to store the track.
® Repeat steps Jto 5to store other discs
and tracks.
6 Press ■ once to end programming.
The total number of tracks
programmed and total playing time
appear on the display.
Notes:
- If the total playing time is more than
" or if one of the programmed
tracks has a number greater than 30,
then "......... " appears on the display
instead of the total playing time.
- During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.