Connecting to an audio system – Philips DVD420AT User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connections J For details of output sound, see
Connecting to an Audio System
You can listen to the sound of the discs in stereo.
Connecting to an Audio System
Setting of the sound output
From the on-screen displays, set “AUDIO OUT SEL.” to “PCM.”
To wall outlet
i
cable. When using the S video cable, there
is no need to connect the yellow video
cable.
a video input jack
Notes
• Refer to the owner’s manual of the connected equipment (TV, audio system) as well.
• When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet
before making any connections.
• If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD video player
away from the tuner and radio.
• The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level.
Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the DVD video player’s power cord. If you leave the amplifier power on, the speakers
may be damaged.
12