Philips 21PV340/07 - Manual (Page 27)

7. PROGRAMMED RECORDING (TIMER)
Use programmed recording to automatically start and stop a
recording at a later date.
The TV-Video Combi requires the following information for
each programmed recording:
*the date you want to make the recording
*the programme numberforthe TV channel you want to
record
* the start and stop time of the recording
* VPS/PDC on or off
The TV-Video Combi stores all above mentioned information in
a so-called TIMER-Block. You can programme up to 6 TIMER
blocks a whole month in advance.
'VPS' (Video Programming System)/
'PDC' (Programme Delivery Control)
With 'VPS/PDC', the TV station controls the start time and the
length of the programmed recording. If a TV programme
begins earlier or ends laterthan planned, the TV-Video Combi
switches on and off at the right time.
You must enter the start time exactly to the minuteduring
programming.
If you would like to programme a time that differs from the
VPS/PDC time, you must switch off 'VPS/PDC'.
Programming a recording
(with VIDEO Plus+')
m Press the ITIIVIER0I button on the remote control.
H] Enterthe entire PlusCode number. This number which
can consist of up to nine digits, is listed in your TV guide
next to the start time of the respective TV programme,
e.g.: 5-234-89 or 5 234 89
Enter 523489forthe PlusCode programming number.
D>
>
If you would like to use 'VPS/PDC' to programme the
recording and an additional start time is indicated,
e.g.: (VPS/PDC21.09), you must enter the ShowView
number for the 'VPS/PDC' time.
e.g.:(VPS/PDC21.09) 405-564-898
Enter 405564898 for programming using 'VPS/PDC'.
If you make a mistake, you can clear your entry
using the I clearicd I button.
m Use I SELECT I to select repeated daily or weekly recording.
'ONCE': One-time recording.
'MO-FR': Daily recordings from Monday through Friday.
'WEEK.': Recordings on the same day every week.
0 Confirm with the [ ok ] button. Upon confirmation the
respective information will appear on the TV screen.
When entering the PlusCode programme number, the
TV-Video Combi receives all necessary information to
programme a recording.
|p.
[
TIMER programming
DATE REP. PROG. START PDC END
01 ONCE 01 20:15 + 21:30
E
REP.: SELECT STORE: OK
1
p>- If'SELECT PROG. NR.'appears onthe screen,
the TV channel has not yet been allocated to the
PlusCode number. Select the desired programme
number using the number buttons [^on the
remote control and confirm with the [ ok ] button.
p>
If'PLUSCODE NUMBER NOT VALID'appears on
the screen, the PlusCode number is incorrect.
Correct your entry or cancel using the iMENUl button.