Philips 21PV340/07 - Manual (Page 10)

1. CONNECT THE TV-VIDEO COMBI
Important for the United Kingdom Connecting the cables
This apparatus is fitted with an approved moulded 13 Amp
plug. To change a fuse in this type of plug proceed as follows:
m Remove fuse cover and fuse.
m Fix new fuse which should be a BS1362 5A, A.S.T.A. or
BSI approved type.
m Refit the fuse cover.
if the fitted plug is not suitable foryour socket outlets, it should
be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of
5A. If a plug without a fuse is used, the fuse at the distribution
board should not be greater than 5A.
I Note: * The severed plug must be destroyed to avoid
a possible shock hazard should it be inserted into a
13A socket elsewhere.
I>
How to connect a plug:
The wires in the mains lead are coloured in accordance with
the following code:
BLUE-'NEUTRAL' ('N')
BROWN-'LIVE'('L')
Ш The BLUE wire must be connected to the terminal which
is marked with the letter 'N' or coloured BLACK.
Ц] The BROWN wire must be connected to the terminal
which is marked with the letter 'L' or coloured RED.
Гб1
Do not connect either wires to the earth terminal in the
plug which is marked with the letter'E' or by the safety
earth symbol + or coloured green or green-and-yellow.
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead - not imply over the
two wires.
m Insert the aerial plug into the hr [socket.
Insert the plug of the mains cable into the wall socket.
[B Ifthe little red standby light ( standby ®) at the front panel
of the set is not lit, please switch on the set using the
main power switch. The power switch is located on
the left side panel of the set.
This text will appear on the TV screen.
E LANGUAGE
I
< ENGLISH >
Ё STORE: OK
I
Placing the batteries in the remote control
m Open up the battery compartment of your remote control
and place the batteries in it as shown in the picture.
0 Then, read the section 'Initial installation' in the chapter
'INSTALLING YOUR VIDEO RECORDER'.
Close the battery compartment.