beautypg.com

Troubleshooting – Philips FW338C User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

TROUBLESHOOTING

Warning! Under no circumstances should you try

to repair the system yourseif, as this will invalidate

the warranty.

• If a fault occurs, check the points listed below before

taking the system

for

repair.

• Should any problems persist after you have made

these checks, consult your nearest dealer or service
center,

CD Player Operation___________________

"fJQ DISC" is displayed.

• The disc is inserted upside down.

-> Place CD with printed side up.

Moisture condensation at the lens.

Wait until lens has adjusted to normal room

temperature.

There is no disc in the CD tray.

Insert a CD

The CD is dirty, badly scratched or warped.

Clean or replace the CD.

The CD lens is dirty or dusty

See section under Maintenance.

Radio Reception______________________

Poor radio reception

• The signal strength is too weak.

Adjust the antenna.

The TV or VCR is too close to the stereo system.

-* Separate the stereo system from the TV or VCR.

Connect an external antenna for better reception.

Tape Deck Operation

"RCCORIirwG RCrii'C" is displayed.

• A recording is in progress.

Stop the recording or wait until it is finished.

“TRPC

" is displayed.

• Tape dubbing is only possible in tape mode.

Switch source to tape mode.

Recording or playback cannot be made or there is a
decrease in audio level.

Dirty tape heads, capstans or pressure rollers.

See section on tape deck maintenance.

Magnetic build-up in the record/playback head.

-* Use demagnetizing tape.

General_____________________________

System does not react when any button is pressed.

• Electrostatic discharge.

Press STANDBY-ON to switch the system off. Remove

the AC power plug from the wall outlet, then

reconnect and switch on the system again.

No or poor sound.

• Volume is not turned up.

--Adjust VOLUME.

The headphones are connected.

Disconnect the headphones.

Speakers are not connected or are connected wrongly.

-* Check that the speakers are connected correctly.

Make sure that the stripped speaker wire is clamped.

Reversed left and right sound.

• Speakers are connected wrongly.

Check the speaker connections and location.

Lack of bass sound or apparently imprecise
physical location of musical instruments.

| -|

• Speakers are connected wrongly.

ki

-* Check the speaker connection for proper phasing, red/

black wires to red/biack terminals.

Remote control has no effect on the system.

• The distance to the system is too large.

-* Reduce the distance.

• Batteries are inserted incorrectly.

-* Insert the batteries with their polarities {+/- signs) as

indicated..

Batteries are exhausted.

-* Replace the batteries.

• Wrong source is selected.

-* Select the source (CD, TUNER, etc.) before pressing

the function button, (PLAY, PREV/NEXT, etc.).

Timer not working.

• Timer is not switched on.

-* Press CLOCK• TIMER to switch on the timer.

• Dubbing/recording is in progress.

Stop dubbing/recording.

System displays features automatically; buttons

flash continuously.

• Demonstration mode is switched on.

Press and hold STOPfor 3 seconds to switch off

the demonstration.

27