Philips FW338C - Manual (Page 18)

^ ProaTamming Tracks
CD
Programming tracks of a loaded CD is possible in the stop
mode. The display will indicate the total tracks stored in
the program. Up to 40 tracks can be stored in the memory
in any order. When 40 tracks are stored and you attempt
to store another track, the display will show
"PROSRPi/1
rULL".
1 Load the desired discs in the disc trays.
2 Press PROGRAM to start programming.
— The PROGRAM flag starts flashing.
3 Press the CD 1* *CD 2»CD 3 button to select the disc.
4 Press PREV M or NEXT ►! to select the desired
track.
5 Press PROGRAM to store the track.
• Repeat steps 3to 5to store other discs and tracks.
6 Press STOP ■ once to end programming mode.
— The total number of tracks programmed and total
playing time appear on the display.
Note:
- If the total playing time is more than ''33:53" or if
one of the programmed tracks has a number greater
than 30, then -; - -" appears in the display instead
of the total playing time.
- During programming, if no button is pressed within 20
seconds, the system will exit program mode
automatically.
Playing the program
1 Press PLAY ► to start program playback.
— "PLRy PRDERRfr appears on the display.
The track number and elapsed playing time of the
current track will appear on the display.
• If you press REPEAT during program playback, the
current track will be played repeatedly.
The REPEAT and PROGRAM flags will be displayed.
2 Press STOP ■ to stop program playback.
Note:
- If you press any of the 3 CD DIRECT PLAY buttons, the
system will play the selected disc or track and the
stored program will be ignored temporarily. The
PROGRAM flag will also temporarily disappear from
the display and then reappear when the playback for
the selected disc ends.
Reviewing the program________________
Reviewing of the program is only possible in the stop
mode.
• Press PREV M or NEXT H repeatedly to review the
programmed tracks.
• Press STOP ■ to exit review mode.
Erasing the program (In the stop model
•
Press CLEAR on the system.
"PROGRRM CLERRE3" will be displayed.
Note:
- The program will be erased when the system is
disconnected from the power supply. If the CD
carousel is opened, the tracks belonging to the outer
two trays will be erased and the display will show
'CLERRES".
Shuffle ¡only on remote control)
It will play all the available discs and their tracks in
random order. Shuffle may also be used when tracks are
programmed.
To shuffle all the discs and tracks
1 Press SHUFFLE.
"SHurPLE" will be displayed.
The SHUFFLE flag, the disc and the track selected
at random appear on the display,
• The discs and the tracks will norv be played in random
order until you press STOP ■.
• If you press REPEAT during shuffle, the current track
will be played repeatedly.
— The REPEAT and PROGRAM flags will be displayed,
2 Press SHUFFLE again to resume normal playback.
— The SHUFFLE flag disappears from the display.
Repeat (only on remote control!
It will play the current track repeatedly.
1 Press REPEAT during CD playback.
- "REPERT TRRCK" will be displayed.
The REPEAT flag appears on the display.
• The track will now be played repeatedly until you
press STOP ■.
2 Press REPEAT again to resume normal playback.
-* The REPEAT flag disappears from the display.
18