Inserting batteries into the remote control, The preparation procedures, Seconds – Philips FW338C User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CONTROLS

OPERATING THE SYSTEM

Inserting batteries into the Remote

Control_____________________________

• Insert the batteries (Type R03 or AAA) into the

remote control as shown in the battery compartment.

To avoid damage from possible battery leakage,

remove dead batteries or batteries that will not be

used for a long time. For replacement, use type R03 or
AAA batteries.

the preparation procedures.

Demonstration mode

The system has a demonstration mode that shows the

various features offered by the system.

Whenever the

system is switched on from the wall socket, the

demonstration mode will start automatically.

Note:
-

During demonstration mode, if you press any source

lor standby-onj button, the system will switch to the

respective (or standby} mode.

- When the system is switched to standby mode. 5

seconds later, the demonstration mode will resume.

seconds

to stop the demonstration.

The demonstration mode will be switched off

permanently.

-* The system will switch to standby mode.